Onkyo TX SR674 Owner Manual - Page 39
Press [ENTER].
UPC - 751398007118
View all Onkyo TX SR674 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
First Time Setup-Continued 2 Put the speaker setup micro- 4 phone at measurement point 1. Auto Speaker Setup Please place microphone at center of listening area at ear height. Push Enter:Next Notes: • Make sure the microphone is hori- zontal. • If there's an obstacle between the microphone and any speaker, the automatic setup will not work correctly. Set up the room as you would when enjoying a DVD. • Positioning the microphone close to where your ears would normally be will provide better results. You can adjust the height of the microphone by using a tripod or level table. • It takes about 10 minutes to complete the automatic speaker setup. Connect the setup microphone to the SETUP MIC jack. Notes: • If the AV receiver was previously muted, it will be unmuted. • Automatic speaker setup cannot be performed while a pair of headphones is connected. 3 Press [ENTER]. The automatic speaker setup starts. Auto Speaker Setup Do not unplug Setup Mic. Please, keep quiet. Now measuring... A test tone is output by each speaker in turn, as the Audyssey2EQ function determines which speakers are connected. This takes a few minutes. Note: If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so don't make any noise. The speaker detect results appear. Auto Speaker Setup ----SP Detect Result---- FL:Yes FR:Yes SL:Yes SR:Yes SBL:Yes SBR:Yes C:No SW:Yes Next Retry Cancel "Yes" means that the speaker was detected. "No" means that no speaker was detected. If you agree with the results, use the Up and Down [ ]/[ ] buttons to select Next, and then press [ENTER]. The options are: Next: Proceed to the next step. Retry: Return to step 2 and try again. Cancel: Cancel the automatic speaker setup. 39