Onkyo TX SR674 Owner Manual - Page 51
Setting the Display Brightness, Muting the AV Receiver, Using the Sleep Timer, Using Headphones
UPC - 751398007118
View all Onkyo TX SR674 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Basic Operations-Continued DIMMER ON/STANDBY ZONE2 REMOTE MODE RECEIVER TAPE INPUT SELECTOR 1 2 3 V1 V2 V3 DVD M D/CDR C D HDD 4 5 6 TV V4 MULTI CH DVD 7 8 9 VCR TAPE TUNER 10 11 +10 0 C D 12 CABLE CLR SAT D TUN --/--- ENT DIMMER SLEEP TV VOL INPUT GUIDE TOP MENU CH DISC ALBUM VOL PREVIOUS MENU PLAYLIST/CAT ENTER MUTING PLAYLIST/CAT Press [RECEIVER] first SLEEP MUTING Setting the Display Brightness You can adjust the brightness of the display. RECEIVER DIMMER Press the [RECEIVER] button, and then press the [DIMMER] button repeatedly to select: • Normal+VOLUME light on. • Normal+VOLUME light off. • Dim+VOLUME light off. • Dimmer+VOLUME light off. Using the Sleep Timer With the sleep timer, you can set the AV receiver to turn off automatically after a specified period. RECEIVER SLEEP Press the [RECEIVER] button, and then press the [SLEEP] button repeatedly to select the required sleep time. The sleep time can be set from 90 to 10 minutes in 10 minute steps. The SLEEP indicator appears on the display when the sleep timer has been set. The specified sleep time appears on the display for about five seconds, then the previous display reappears. If you need to cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears. To check the time remaining until the AV receiver sleeps, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you'll shorten the sleep time by 10 minutes. Using Headphones You can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver's PHONES jack for private listening, as shown. Muting the AV Receiver You can temporarily mute the output of the AV receiver. Press the [RECEIVER] button, RECEIVER and then press the [MUTING] but- ton. The output is muted and the MUTING indicator flashes on the display, as shown. MUTING To unmute the AV receiver, press the [MUTING] button again, or adjust the volume. The Mute function is cancelled when the AV receiver is set to Standby. Notes: • Always turn down the volume before connecting your headphones. • The speakers are turned off while the headphones plug is inserted in the PHONES jack (Zone 2 speakers are not turned off). • When you connect a pair of headphones, the listening mode is set to Stereo, unless it's already set to Stereo, Mono, Direct, or Pure Audio (not North American models). • Only the Stereo, Direct, Pure Audio (not North American models), and Mono listening modes can be used with headphones (the listening modes available also depend on the currently selected input source). • When the multichannel input is used, only the front left and right audio can be heard in the headphones. • To adjust the headphone level, press the [CH SEL] button on the remote controller, and then press the [LEVEL +]/[LEVEL -] buttons. You can adjust the level between -12 dB and +12 dB. 51