Panasonic AG DVC20 Dv Camcorder - Page 10

Preparation Using the AU-BP402 or AJ-BP490 battery pack made by Panasonic Recharge the battery pack using the battery charger specifically designed for each individual battery pack. For the charging time and other details, refer to the operating instructions of the battery charger used. 1 Remove the battery holder. Disconnect these. 3 Connect the plug of the battery pack to the connector inside the battery case, and insert the battery pack into the case. Battery holder Disconnect these. 2 Attach the battery case to the unit. 1Connect the unit's cable with the cable of the AU-M402H battery case. 2Use a screwdriver to attach the AU-M402H battery case to the unit. The holes for tightening the screws can be seen when the cover is opened and the rubber caps are raised. Use a screwdriver to tighten the screws, and attach the battery case to the unit. Ensure that the screws are tightened up as far as they will go. ≥Do not pull the rubber caps with great force. ≥Be careful not to catch up the cables when attaching the battery case. Screws Rubber caps Label surface AU-BP402 battery pack Ensure that the power is turned off before connecting or disconnecting the plugs. 4 Set the battery type. Select the battery type using on the sub-menu screen. Select "TYPE A" if the AJ-BP490 is to be used; select "NiCd12" if the AU-BP402 is to be used. (See page 34) Connect here. AU-M402H battery case 10