Panasonic BT-LH910G Operating Instructions - Page 34
System Config, Description, Sub Window, Menu Position, Status, Display, Battery, Remain, Warning
View all Panasonic BT-LH910G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Main Menu (continued) SYSTEM CONFIG The underlined values are factory preset setting values. Sub menu Settings Description SUB WINDOW FULL PART Selects sub-window type. Reduces the entire images for both input signals and places them side by side. Cuts out the center of the images for both input signals and places them side by side (the images are shown at their original size). MENU POSITION CENTER LB RB RT LT Positions the on-screen menu. Center of the screen Left Bottom Right Bottom Right Top Left Top STATUS DISPLAY *1 CONTINUE 3SEC OFF OFF Sets the display state of the operating status display (page 18). Displayed at all times Displayed for 3 seconds after a status change.*2 Not displayed. BATTERY REMAIN OFF ON Selects whether DC power supply voltage and battery level display. Not displayed. Displayed. WARNING VOLTAGE *3 TYPE1 TYPE2 Sets the near end warning voltage for the battery level display. Select this when you will mainly use an external DC power supply. Near end is approximately 11.3 V. Select this when you will mainly use a battery. Near end is approximately 13.3 V. SETUP LOAD *3 USER5 *4 USER4 *4 USER3 *4 USER2 *4 USER1 *4 FACTORY Loads saved factory defaults (FACTORY) or user data (USER1 USER5) (page 23) . After loading user data, the screen displays the signal selected before user data was loaded. SETUP SAVE USER5 USER4 USER3 USER2 USER1 Up to 5 sets of user data can be saved (page 23). They save menu settings and adjustments made with the picture adjusting knob except "SETUP SAVE/SETUP LOAD." POWER ON SETUP USER5 USER4 USER3 USER2 USER1 FACTORY LAST Selects the settings used when the power is turned on. Starts in the mode used when the power was last turned off. Starts up using the factory defaults. Starts up using USER registered settings. (Continued on next page) *1 When PIXEL to PIXEL, operation is with CONTINUE regardless of the setting. *2 When PIXEL TO PIXEL/3D assist mode, the 3SEC OFF setting becomes equivalent to CONTINUE. *3 When the BATTERY REMAIN display setting is OFF, near end warning display does not occur. *4 The settings of USER1 to USER 5 and FACTORY are the same at the time of shipment from the factory. 34