Panasonic BT-LH910G Operating Instructions - Page 43
Press the, WFM/VECTOR, button again
![]() |
View all Panasonic BT-LH910G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Main Menu (continued) ■■"WFM/VECTOR" The "WFM/VECTOR" function enables display of the waveform and vector display. Use "DISPLAY SETUP" in the main menu to select "WFM" and "VECTOR" display. (page 50) Press the button ([FUNCTION1] to [FUNCTION3] (page 39)) to which the "WFM/VECTOR" function has been assigned to switch the display in the following order. WFM/VECTOR OFF → WFM Y ON → WFM R ON → WFM G ON → WFM B ON → VECTOR (x1 to x8) •• This assumes that the "WFM/VECTOR" function has been assigned to any of the [FUNCTION1] to [FUNCTION3] buttons. WFM is displayed in the order of the Y signal, R signal, G signal, and B signal. Press the FUNCTION button to which the WFM/VECTOR function has been assigned. Normal screen Press the button again WFM display (Y→R→G→B) Press the button again VECTOR display *1 *1 Displayed only for SDI signal input. •• The scale display is as shown below. 100 % WFM (waveform display) VECTOR (vector display) These examples show 16:9 aspect ratio images. This dotted line is 109%. 50 % 0 % A dotted line indicates for each 10% increase. This dotted line is -4%. I axis The frame is ±2.5°, ±2.5 % Q axis 43
![](/manual_guide/products/panasonic-btlh910gj-operating-instructions-0f91241/43.png)