Panasonic HC-X1500 HC-X1500 Advanced Operating Manual - Page 190

Chapter 10 Notes - Warning system Message Screen display Camera image screen Description Behavior and cause [CANNOT PLAY.] This is a clip that cannot be played back. (When it cannot be played back due to difference of the system frequency, etc.) An error has occurred during playback, and the playback has stopped. ≥ Confirm if the system frequency of the clip is the same as the system frequency of the unit. ≥ Check the clip. [CANNOT DELETE.] This is a clip that cannot be deleted. ≥ Match the device and content versions. [CANNOT RECORD. THE NUMBER OF CLIPS HAS EXCEEDED THE MAXIMUM LIMIT.] The number of clips that can be recorded has reached the ≥ Replace the memory card or delete unnecessary clips. maximum. [CARD ERROR. PLEASE REFORMAT.] Formatting of the memory card has failed. ≥ Format it again. [CANNOT COPY TO SAME CARD.] The clip recorded over multiple memory cards cannot be copied to a same card. ≥ Copy to a card not containing a clip that is recorded over multiple memory cards. [Repair failed.] Repairing the clip where an error occurred has failed because the power was disconnected or the memory card was removed during recording. Restoring of the management information has failed. ≥ Check the memory card. [UNABLE TO FORMAT.] This memory card cannot be formatted. ≥ Check the memory card. [CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.] Management information cannot be restored due to insufficient remaining battery level. ≥ Replace with a fully charged battery, or connect the AC adaptor. [CANNOT PROTECT.] This is a clip that cannot be protected. ≥ Match the device and content versions. [THE CLIP IS PROTECTED. PLEASE The clip is protected so it cannot be deleted. CANCEL PROTECTION.] ≥ Cancel the protect on the clip. [THUMBNAIL DATA ERROR IS DETECTED.] An error occurred in the thumbnail information of the memory card. ≥ Restoring of the management information is performed automatically after this. [CANNOT RECORD INCOMPATIBLE CONTROL DATA.] The version of the management information on the memory card is not supported. ≥ Match the device and content versions. [CANNOT SET.] This cannot be set. ≥ Perform the setting after making it possible to set. [THIS CLIP CANNOT BE COPIED.] The clip cannot be copied. ≥ Copy the clips other than the corresponding clip. [CONTROL DATA ERROR HAS BEEN DETECTED. (SD CARD)] An error occurred in the management information of the memory card. ≥ Restoring of the management information is performed automatically after this. [COPY FAILED. PLEASE CHECK THE CARD.] The clip has failed to copy due to an error in the memory card. ≥ Check the memory card. [COPY TERMINATION IN PROGRESS DUE TO INSUFFICIENT BATTERY POWER. DO NOT SWITCH OFF.] Remaining battery level became low while copying the clip. ≥ The copy is canceled. ≥ Replace with a fully charged battery, or connect the AC adaptor. [COPY TERMINATED DUE TO Copying of a clip is canceled due to insufficient remaining ≥ Replace with a fully charged battery, or connect the AC INSUFFICIENT BATTERY POWER.] battery level. adaptor. [CANNOT COPY - THE NUMBER OF The number of clips that can be copied has reached the CLIPS HAS REACHED MAXIMUM.] maximum. ≥ Replace the memory card in the copy destination or delete unnecessary clips. [LOW BATTERY. PLEASE CONNECT It is trying to copy a clip or update the firmware of the unit AC ADAPTOR OR CHANGE when the remaining battery level is insufficient. BATTERY.] ≥ Replace with a fully charged battery, or connect the AC adaptor. [CANNOT PLAY THIS CLIP ON THIS This is a clip that cannot be played back with the unit. MODEL.] ≥ Playback on a device that can playback. [Cannot copy: contains recordings from other devices.] The clip recorded in other device cannot be copied. ≥ Copy the clips other than the corresponding clip. [ERROR HAS OCCURRED. TO REPAIR THE CONTROL DATA, PLEASE CONNECT AC ADAPTOR OR CHANGE BATTERY.] The remaining battery level was low when the restoring of ≥ Replace with a fully charged battery, or connect the AC the management information is started. adaptor. [INVALID] Operation is disabled. ≥ Operate after the operation becomes enabled. [Cannot record - Playlist capacity is full.] The unit tried to record on a memory card where the number of playlists for recording has reached the maximum. ≥ Replace the memory card or delete unnecessary clips. [Cannot copy - Playlist capacity is full.] The unit tried to copy to a memory card where the number ≥ Replace the memory card or delete unnecessary clips. of playlists for recording has reached the maximum. [Exceeds capacity. Please reselect.] The remaining recording capacity of the memory card for the copy destination is insufficient. ≥ Select the clip to copy again, or secure enough space in the remaining recording capacity on the memory card for the copy destination. [Check the destination media.] An error has occurred on the memory card for the copy destination while copying. ≥ Confirm the memory card for the copy destination. - 190 -