Panasonic HC-X1500 HC-X1500 Advanced Operating Manual - Page 37
Turning on/off the power, Turning the unit on and off with the power button
View all Panasonic HC-X1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Chapter 3 Preparation - Turning on/off the power Turning on/off the power Turning the unit on and off with the power button 1 Open the LCD monitor and press the power button to turn on the unit. A The status indicator lights on. ∫ To turn off the unit Hold down the power button until the status indicator goes off. @ NOTE 0 The [TIME ZONE] screen is displayed when the power is turned on for the first time. (l 17) Set the time zone, date, and time. 0 The built-in battery (rechargeable battery) will discharge. The setting for date/time may be initialized when the unit is not turned on for approximately 6 months. Set the date/time again after charging the built-in battery. (l 38) Turning the unit on and off with the LCD monitor/viewfinder Opening the LCD monitor or extending the viewfinder turns on the unit. Closing the LCD monitor/viewfinder turns off the unit. During normal use, you may find it convenient to turn the unit on/off using the LCD monitor or viewfinder. ≥ The unit will not turn off unless the LCD monitor is closed and the viewfinder is retracted. ≥ The unit will not turn off during recording or while connected to a network even if the LCD monitor is closed and the viewfinder is retracted. ≥ In the following cases, opening the LCD monitor or extending the viewfinder does not turn on the unit. Press the power button to turn on the unit. j When the unit is originally purchased j When you have turned off the unit using the power button Charging the built-in battery The date/time set in the unit is maintained by the built-in battery. If this unit is left without turning the power on, and then when you turn the power on and [BACKUP BATT EMPTY] is displayed on the viewfinder and LCD monitor for approximately 5 seconds, the built-in battery is exhausted. The date of the internal clock of the unit resets to January 1, 2020 if the built-in battery is exhausted. Charge the built-in battery with the following procedure. 1 Press the power button to turn off the unit. 2 Connect a fully charged battery or the AC adaptor to the unit. For details about the connection of the battery or AC adaptor, refer to "Power supply". (l 28) 3 Leave the unit for approximately 24 hours. The built-in battery will be charged. The built-in battery recharges even when the power is on. Check the date/time setting and the time code after charging. If [INTERNAL CLOCK HAS RESET] [] is displayed on the STATUS screen of the mode check, set the date/time of the internal clock. (l 38) 4 Press the power button to turn on the power, and confirm that [BACKUP BATT EMPTY] is not displayed on the LCD monitor. If [BACKUP BATT EMPTY] is still displayed after charging, the built-in battery needs to be replaced. Consult your dealer. - 37 -