Panasonic WJ-NV300 Installation Guide - Page 17
Precautions for installation
View all Panasonic WJ-NV300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Precautions for installation This product is designed to be used indoors. Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation. Do not place this product in the following places: • Locations exposed to direct sunlight • Locations subject to having strong vibration or impact • Locations near magnetic field sources such as a television or speakers • Locations where condensation forms easily, where temperature changes greatly or where humidity level is high • Locations subject to steam and oil smoke such as a kitchen • Locations which are not level • Locations subject to dust • Locations where it may get wet from rain or water splash Do not install this product in locations where the product or the cables can be destroyed or damaged by persons with malicious intent. Place this product horizontally on a level surface. Do not place this product in an upright position. In addition, clear a space of approx. 5 cm {2 inches} from the both sides, the top, the bottom and the rear. More than 5 cm {2 inches} More than 5 cm {2 inches} More than 5 cm {2 inches} Heat dissipation To prevent this product from overheating, heed the following. Failure to observe this may cause fire or trouble. • Do not block the ventilation openings. Maintain the product periodically to prevent dust from blocking openings. • The lifetime of the cooling fan is limited by use. It is recommended to replace them after around 30 000 hours of operation. Contact your dealer for replacement of the cooling fans. • Clear a space of more than 5 cm {2 inches} from both sides, the top, and the rear of the product. Do not block the ventilation openings on the front side since this product is designed to cool the hard disk drives by inhaling air from the front. Avoid placing this product near noise sources If the cables are placed near noise sources such as fluorescent lamps, noises may be produced. In this case, rewire avoiding the noise sources, or move the product to a place far from the source. Grounding Confirm that the wire is connected from the SIGNAL GND terminal to earth ground. A grounding connection must be made before connecting the power plug or this product to the main power supply. When disconnecting the grounding wire, make sure that the power plug of this product is disconnected from the main power supply. For BNC cable connection Use only the recommended plug below when connecting the BNC plug to the connectors on the rear panel of this product. Applicable plug: M IL-C39012BCN,CMcaILb-leC(3lo9c0al1ly2p/1ro6cFuroedr )BS CECC2212: 1981 * Suffixes attached to the standards may be updated. BNC cable (locally procured) Plug (locally procured) Plug (locally procured) Tip dimensions inside the recommended BNC plug ø1.32 mm - ø1.37 mm {ø0.052 inches - ø0.054 inches} ø1.32 mm - ø1.37 mm {ø0.052 inches - ø0.054 inches} ø0.13 mm - ø0.69 mm {ø0.005 inches - ø0.027 inches} Important: • A comø{ø0p0.1.a03t0ibm5lemincp-hløue0sg.6-s9øh0ma.0lml2b7einucsheeds}. Failure to observe this may cause trouble such as poor contact. At worst, the connector of this product may be damaged. Avoid placing receptacles that contain liquids such as water near this product. If liquid spills onto this product, it may cause fire or an electric shock. Shielded (STP) LAN cables must be used with this unit to ensure compliance with EMC standards. 17