Panasonic WJ-NV300 Installation Guide - Page 20

Rear view q Power cord inlet !2 SIGNAL GND terminal !1 HDD slot AC IN SIGNAL GND HDD 2 VIDEO AUDIO OUT ALARM/ CONTROL w Mouse connection port e Video output connector (BNC) r Audio output connector (RCA pin jack) t Alarm/Control connector (D-sub 25-pin) (This illustration represents WJ-NV300K.) q Power cord inlet [AC IN] Connect the provided power cord to this inlet. The power plug of the recorder is 2-prong plug equipped with a grounding terminal. w Mouse connection port [MOUSE] The provided mouse is connected to this port. e Video output connector (BNC) [VIDEO OUT] Connect a sub monitor (BNC) to this connector. Same images output from the sub monitor output connector (HDMI) will be output from this connector. r Audio output connector (RCA pin jack) [AUDIO OUT] Connect such device as a powered speaker. Same audio output to the main monitor will be output from this connector. t Alarm/Control connector (D-sub 25-pin) [ALARM/CONTROL] Connect a control switch to control the recorder using an external device such as a sensor or a door switch or an external alarm device such as a buzzer or a lamp. y Expansion connector [EXT STORAGE 1/2] Connect the optional extension unit (WJ-HDE400) to this connector using the dedicated connection cable provided with the extension unit. u Network port (PC port) [PC] Connect the recorder with a PC via a network compatible with 10BASE-T, 100BASE-TX or 1000BASE-T. Use this port when the cameras and the PC are connected to different network. HDD 1 EXT STORAGE 2 1 10/100/1000BASE-T AV OUT PC CAMERA/PC MAIN VIDEO OUT SUB y Expansion connector !0 S ub monitor output connector (HDMI) o Main monitor output connector (HDMI) i Network port (Camera/PC port) u Network port (PC port) i Network port (Camera/PC port) [CAMERA/PC] Connect the recorder with a PC and cameras via a network compatible with 10BASE-T, 100BASE-TX or 1000BASE-T. When the port is being accessed, the access indicator (green) blinks. When the port is being linked, the link indicator (orange) lights. 10/100/1000BASE-T PC CAMERA/PC Access indicator Link indicator o Main monitor output connector (HDMI) [AV OUT MAIN] This connector is used to connect to an HDMI-ready monitor (the main monitor). It displays live images, recorded images, or the setup menu of the recorder. !0 Sub monitor output connector (HDMI) [VIDEO OUT SUB] This connector is used to connect to an HDMI-ready monitor (sub monitor). Only the live images will be displayed. !1 HDD slot [HDD1/HDD2] Hard disk drives (locally procured) can be installed into these slots. Contact your dealer for installing/replacing the hard disk drives. !2 SIGNAL GND terminal [SIGNAL GND] Connect this terminal with the SIGNAL GND terminals of the devices in the system for signal ground. When operating the recorder and the devices in the system without signal ground, oscillation or noise may be produced. 20