Panasonic WJ-NV300 Installation Guide - Page 30
Connection for the auto time adjustment function, Connection of the control output
View all Panasonic WJ-NV300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Connection for the auto time adjustment function When a signal output from the other device is supplied to the time adjustment signal input (pin no. 20) and the time difference between the recorder and the other device is 29 minutes or less, the clock of the recorder will be set to the time set for the other device. When a signal output is supplied to the recorder 29 minutes before/after the hour, the clock of the recorder will be set to the hour (nn:00:00). ("nn" is the hour.) Example: • Signal is supplied at 2:50:00 pm → Set at 3:00:00 pm • Signal input supplied at 3:28:45 pm → Set at 3:00:00 pm • Signal is supplied at 3:29:30 pm → Time will not be adjusted. (Signal ground) (Time adjustment signal input) Terminal of the other device Output for the indicators on the front panel 13 20 Signal ground Sensor signal input Alarm input Alarm reset input Series recording output Time adjustment signal input Signal ground Alarm output Alarm reset output Alarm recording During recording Disk Buzzer output System error output Thermal error output Time adjustment signal output Series recording output ALARM/CONTROL Important: • The clock will not be adjusted during recording. Note: • When adjusting the time using the time adjustment signal input, select "On" for "Auto time adjustment". (☞ Operating Instructions (PDF)) Connection of the control output When an alarm device such as a buzzer or a lamp is connected, the signal output from pin no. 10 and pin nos. 15 - 19 can be used to notify the status by sounding a buzzer or lighting a lamp. The connection example of the HDD error output (pin no. 16) is as follows. (Signal ground) (HDD error output) 13 16 Alarming device Relays, etc.* ALARM/CONTROL * Attached when necessary 30