Panasonic WVNP1004 WVNP1004 User Guide - Page 54

How to adjust white balance (When "AWC" is selected "WHITE BAL") q Select "AWC" for "WHITE BAL", and then press the [Left] button to switch to "AWC→PUSH SW". w Press the [SET] button to adjust white balance. The "PUSH SW" part will be highlighted in the process of the adjustment. When the highlighted indication returns to normal indication, adjustment of white balance is complete. e Press the [Right] button to select "AWC". Refer to page 61 for descriptions of how to adjust white balance finely. Note: Operating color temperature range is approx. 2 000 K - 10 000 K. When white balance is out of operating range or illuminance of subject is too low, white balance adjustment may not be complete. In this case, the "PUSH SW" part remains being highlighted. [DNR] When this function (digital noise reduction) is active, noise may be automatically reduced under a low illuminance. Select an effect level "LOW" or "HIGH" for the digital noise reduction. LOW: Low level of noise reduction effect HIGH: High level of noise reduction effect Default: HIGH [BW MODE] Configure the settings relating to the B/W mode. Refer to page 62 for descriptions of how to configure the B/W mode setting. [PRIVACY ZONE] When there is a zone that is not to be displayed, set the zone as a privacy zone to not to display. Up to 8 privacy zones can be set and the following are available to identify them on the screen. ON (1): Display in gray color ON (2): Display in mosaic OFF: Display without effect for identification purpose Refer to page 63 for descriptions of how to set privacy zones. Default: OFF Note: Privacy zones will not function just in the process of initialization just after turning the power on. [EL-ZOOM] Select "ON" or "OFF" to determine whether or not to use the electronic zoom. ON: Use the electronic zoom. Images can be enlarged up to fivefold (x5). Refer to page 64 for descriptions of how to adjust the electronic zoom. OFF: Does not use the electronic zoom. Default: OFF [STABILIZER] Select "ON" or "OFF" to determine whether or not to use the image stabilizer to prevent shaky images. It is effective to use this function when the camera is installed on a pole, etc. ON: Image shake will be stabilized. OFF: Image shake will not be stabilized. Default: OFF Important: • When "ON" is selected, the angular field of view will become narrower and the image resolution will be coarse. When "ON" is selected, install the camera while checking the angular field of view and the resolution. • The image stabilizer may sometimes not function for the following subject. • Dark subject • A subject whose brightness difference is almost none (white wall, etc.) • A subject that vibrates at high pitch such as mechanical vibration • A subject whose vibration amplitude is large 54