Philips LC1241 User Guide - Page 19

8. OPERATION Picture control PICTURE CONTROL - The projector's picture is set to standard specifications at the factory. However, you can adjust the image to suit your own preferences by using the Data or Video ADJUST feature. - The projector will store the last used settings for every source. So when you switch from one source to another, the settings of the source switched from will be stored and the settings of the source switched to will be recalled. - When the projector is switched off and on again the settings for the selected source will be recalled again. - Three memory modes allow you to adjust and save up to three sets of settings (see 'Personal Preferences'). DATA MODE INPUT SIGNAL Data mode input selection Ordinarily, the type of input signal is detected and the correct resolution mode is automatically selected. However, for some signals, 'Special Modes' on the 'Fine Sync' menu screen may need to be changed to match the computer display mode. 1. Press Menu. 2. Press 1 / 2 to select 'Fine Sync'. 3. Press 3 / 4 to select 'Special Modes'. VIDEO MODE INPUT SIGNAL Video mode system selection The video input system mode is preset to 'Auto'; however, it can be changed to a specific system mode, if the selected system mode is not compatible with the connected audiovisual equipment. 1. Press Menu. 2. Press 1 / 2 to select 'Options'. 3. Press 3 / 4 to select 'Video System'. 4. Press OK to move into the Special Modes. 5. Press 4 to select the optimal resolution mode. 6. Press OK to save the setting. 7. To exit from the GUI, press Menu. 4. Press OK to move into the Video System mode. 5. Press 4 to select the desired video system mode. 6. Press OK to save the setting. 7. To exit from the GUI, press Menu. Notes: - Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see.) - When inputting DTV 480P signals, select '480P' in step 4 above. 17