Pioneer PDV-LC10 Owner's Manual - Page 16
Remote Control Unit and Main Unit Preparations - replacement battery
View all Pioneer PDV-LC10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Remote Control Unit and Main Unit Preparations Notes on using the remote control unit Film • Before using the remote control unit for the first time, pull out the film from the back of the remote control unit. • Do not drop or step on the remote control unit or subject it to shocks. Doing so may damage it. • Note that it may not be possible to operate the remote control unit if there are obstacles between it and the remote sensor. • Do not expose the remote sensor to strong light. Doing so may make operation impossible. • Use the remote control unit within the specified operating range. Replacing the battery 1 Insert your fingernails into a and b on the diagram below, press a in the direction of the arrow, then pull out the battery holder. 3 Fit the battery holder back into place. BEFORE USING 2 Remove the old battery, then insert the new battery into the battery holder with the ª side facing upwards. CR2025 Lithium battery (CR2025) 16 En Note: To prevent leakage of fluid from the lithium battery, remove the battery when not using the remote control unit for long periods of time (one month or more). If the fluid should leak, carefully wipe any fluid out of the battery case, then insert a new lithium battery. WARNING (lithium battery) • Keep out of the reach of children. • Contact a physician immediately if a battery should be swallowed. • Do not take apart, dispose of in flames, charge, heat, solder or short-circuit. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.