Pioneer PDV-LC10 Owner's Manual - Page 73

Various Digital Signal Settings English 96 kHz PCM signal setting 96 kHz PCM is a high quality audio format with a far higher sampling frequency than the 44.1 kHz format used for CDs. This format is used mainly for music DVDs. There is no need to make this setting if the "Digital Jack" setting has already been made with the Setup Navigator. Audio1 2 Video Language General Other Dolby Digital Out - Dolby Digital DTS Out - Off 96kHz PCM Out 96kHz 3 48kHz MPEG Out - 96kHz i Switch 96kHz audio output mode Move SETUP Exit • 96 kHz 3 48 kHz: The 96 kHz signals are down-sampled to 48 kHz before being output. In this mode a Dolby Pro-Logic amplifier or an amplifier equipped with a digital input can be used. • 96 kHz: A 96 kHz compatible amplifier or D/A converter is required to select this mode. Settings: 96 kHz 3 48 kHz* 96 kHz *Factory setting This setting can be changed during playback. MPEG signal setting MPEG is one audio format used with DVDs. There is no need to make this setting if the "Digital Jack" setting has already been made with the Setup Navigator. Audio1 2 Video Language General Other Dolby Digital Out - Dolby Digital DTS Out - Off 96kHz PCM Out - 96kHz 3 48kHz MPEG Out MPEG MPEG 3 PCM i Switch MPEG audio output mode Move SETUP Exit Settings: MPEG MPEG 3 PCM* *Factory setting • MPEG: An MPEG compatible amplifier or D/A converter is required to select this mode. • MPEG 3 PCM: The MPEG signals are converted into linear PCM audio signals (48 kHz) before being output. In this mode a Dolby Pro-Logic amplifier or an amplifier equipped with a digital input can be used. This setting can be changed during playback. 73 En ADVANCED OPERATIONS