Pioneer VSX-1122-K Owner's Manual - Page 63

09 Using other functions Using the sleep timer The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without worrying about the receiver being left on all night. Use the remote control to set the sleep timer. % Press time. to the receiver operation mode, then press SLEEP repeatedly to set the sleep 30 min 60 min Off 90 min ! You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle through the sleep options again. ! The sleep timer is valid for all zones. If any zone is on, the sleep timer continues functioning. Dimming the display You can choose between four brightness levels for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds. % Press to the receiver operation mode, then press DIMMER repeatedly to change the brightness of the front panel display. ! You can also choose to turn the display off. In this case, the FL OFF indicator lights. Checking your system settings Use the status display screen to check your current settings for features such as surround back channel processing and your current MCACC preset. 1 Press to the receiver operation mode, then press STATUS to check the system settings. The front panel display shows each of the following settings for three seconds each: Input Source d Sampling Frequency d MCACC preset d ZONE 2 input. 2 When you're finished, press STATUS again to switch off the display. Resetting the system Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. Set MULTI-ZONE to MULTI ZONE OFF. ! Disconnect the iPod and USB memory device from the receiver beforehand. ! Set the Control with HDMI to OFF (see HDMI Setup on page 55). 1 Switch the receiver into standby. 2 While holding down ENTER on the front panel, press u STANDBY/ON. The display shows RESET c NO d. 3 Select 'RESET' using PRESET k/l, then press ENTER on the front panel. The display shows RESET? OK. 4 Press ENTER to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. ! Note that all settings will be saved, even if the receiver is unplugged. Default system settings Setting Digital Video Converter SPEAKERS Speaker System Front Center Speaker Setting FH/FW Surr SB SW Surround Position Crossover X-Curve DIMMER Inputs See Input function default and possible settings on page 35. HDMI HDMI Audio Control Control Mode ARC (Audio Return Channel) PQLS Standby Through DSP Power On Level Volume Limit Mute Level Phase Control Auto Sound Retriever iPod/USB, INTERNET RADIO, SiriusXM, PANDORA, MUSIC SERVER, FAVORITES, ADAPTER PORT input function Other input functions Sound Delay Dual Mono DRC SACD Gain LFE Attenuate Auto delay Digital Safety Effect Level ExtendedStereo Other modes Default ON SB/FH Normal(SB/FH) SMALL SMALL SMALL SMALL SMALLx2 YES IN REAR 80 Hz OFF Brightest Amp OFF --- (OFF) --- (OFF) --- (AUTO) OFF LAST OFF FULL ON ON OFF 0.0 frame CH1 AUTO 0 dB 0 dB OFF OFF 90 50 63