Pioneer VSX-518-K Owner's Manual - Page 38

09 Additional information Problem Remedy No sound from subwoofer. • Make sure the subwoofer is switched on. • If the subwoofer has a volume knob, make sure it's turned up. • The Dolby Digital or DTS source you are listening to may not have an LFE channel. • Switch the subwoofer setting in Speaker setting on page 31 to YES or PLUS. • Switch the LFEATT (LFE Attenuate) on page 29 to LFEATT 0 or LFEATT 10. The PHASE CONTROL feature • If applicable, check that the lowpass filter switch on your doesn't seem to have an subwoofer is off, or the lowpass cutoff is set to the highest frequency audible effect. setting. If there is a PHASE setting on your subwoofer, set it to 0º (or depending on the subwoofer, the setting where you think it has the best overall effect on the sound). • Make sure the speaker distance setting is correct for all speakers (see Speaker Distance on page 32). Noise during playback of a cassette deck. • Move the cassette deck further from your receiver, until the noise disappears. No sound is output or a noise • Set the digital volume level of the player to full, or to the neutral is output when software with position. DTS is played back. During a playback search, noise is output from a DTS compatible CD player. • This is not a malfunction, but be sure to turn the volume down to prevent the output of loud noise from your speakers. Can't operate the remote control. • Replace the batteries (refer to page 23). • Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel (refer to page 5). • Remove the obstacle or operate from another position. • Avoid exposing the remote sensor on the front panel to direct light. The display is dark or off. • Press DIMMER on the remote repeatedly to return to the default. Resetting the main unit Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down the ADVANCED SURROUND button, press and hold the STANDBY/ON button for about three seconds. 38 En 3 When you see RESET? appear in the display, press the 'ST -' button. OK? shows in the display. 4 Press SOUND RETRIEVER to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings.