Ricoh Aficio MP 9002 Manuals - Page 210
Specifying the File Name, Scan, information is being
View all Ricoh Aficio MP 9002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
10. Troubleshooting Message Causes Solutions "Selected file is currently in use. Password cannot be changed." You cannot change the password of a file whose status is "Waiting..." or that is being edited with DeskTopBinder. Cancel transmission ("Waiting..." status cleared) or the DeskTopBinder setting, and then change the password. "Selected file is currently in use. User name cannot be changed." You cannot change the sender's name whose status is "Waiting..." or that is being edited with DeskTopBinder. Cancel transmission ("Waiting..." status cleared) or the DeskTopBinder setting, and then change the user name. "Sending the data has failed. The data will be resent later." A network error has occurred and a file was not sent correctly. Wait until sending is retried automatically after the preset interval. If sending fails again, contact your administrator. "Some invalid destination(s) contained. Do you want to select only valid destination(s)?" The specified group contains e-mail destinations and Scan to Folder destinations, either of which are incompatible with the specified transmission method. In the message that appears at each transmission, press [Select]. "Some of selected files are currently in use. They could not be deleted." You cannot delete a file which is waiting to be transmitted ("Waiting..." status displayed) or whose information is being changed with DeskTopBinder. Cancel transmission ("Waiting..." status cleared) or the DeskTopBinder setting, and then delete the file. "Some page(s) are near blank. To cancel, press the Stop key." The first page of the document is almost blank. The original's blank side might have been scanned. Be sure to place your originals correctly. "The entered file name contains invalid character(s). Enter the file name again using any of the following 1 byte characters. " 0 to 9 ", " A to Z ", " a to z The file name contains a character that cannot be used. Check the file name set at the time of scanning. For details about characters that can be used in file names, see "Specifying the File Name", Scan . 208