Ricoh Aficio SP C430DN Safety Information - Page 202

6. Paper and Other Media Maintenance Default: [Waterproof Paper 5] If prints made using the paper tray show heavy smudging, use the following procedure to change the paper type setting from the control panel: • Press the [Menu] key, select [Maintenance], [General Settings], and then select [Waterproof Paper Setting]. Select the paper tray, and then select one from [Waterproof Paper 1], [Waterproof Paper 2], [Waterproof Paper 3], [Waterproof Paper 4], or [Waterproof Paper 5]. When specifying paper thickness, remember that a higher number indicates greater thickness. Also, because the paper thickness will normally be detected automatically, change this setting only if a print problem occurs. Special paper 6 Special paper standard Printer setup Printer driver setup Supported paper feed tray Duplex printing When you cannot print successfully with other paper type settings, set special paper. Press the [Menu] key, select [Paper Input], [Paper Type: (tray name)], and then select [Special Paper 1], [Special Paper 2], or [Special Paper 3]. Click [Special 1],[ Special 2], or [Special 3] in the "Paper Type:" list. Any input tray can be used. Make sure paper is not stacked higher than the upper limit mark ( ) inside the tray. When using the bypass tray, make sure paper is not stacked higher than the paper guides on the bypass tray. Supported Preprinted paper Printer setup Printer driver setup Press the [Menu] key, select [Paper Input], [Paper Type: (tray name)], and then select [Preprinted Paper]. Click [Preprinted] in the "Paper Type:" list. 132