Ricoh Aficio SP C430DN Safety Information - Page 782

2. Remote Maintenance Using telnet Display msh> snmp ? Community name configuration msh> snmp "number" name "community_name" • You can configure ten SNMP access settings numbered 1-10. 2 • The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for Client if "public" is not registered in numbers 1-10. When changing the community name, use SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings. • The community name can be entered using up to 15 characters. Deleting community name msh> snmp "number" clear name Access type configuration msh> snmp "number" type "access_type" Access type no read write trap Type of access permission not accessible read only read and write user is notified of trapmessages Protocol configuration Use the following command to set protocols "active" or "inactive". If you set a protocol "inactive", all access settings for that protocol are disabled. msh> snmp {ipv4|ipv6|ipx} {on|off} • Specify "ipv4" for IPv4, "ipv6" for IPv6, or "ipx" for IPX/SPX. • {on} means "active" and {off} means "inactive". • All protocols cannot be turned off concurrently. Configuration of protocol for each registration number To change the protocol of access settings, use the following command. However, if you have disabled a protocol with the above command, activating it here has no effect. msh> snmp "number" active {ipv4|ipv6|ipx} {on|off} Access configuration msh> snmp "number" {ipv4|ipv6|ipx} "address" • You can configure a host address according to the protocol used. 66