Ricoh IM 4000 User Guide - Page 97
See Configuring the Type and Volume of the Sound Emitted When Using Fax, User Guide Full
View all Ricoh IM 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Basic Procedure for Transmitting Faxes • If the Auto Specify Sender Name function is enabled, the sender is automatically specified and you can omit the procedure for specifying a sender. 7. Press [Start]. To cancel transmission after scanning the original, press [Stop] and operate in [Job Status] [Transmission Standby File]. See "Confirming and Handling a Document in the Fax Queue", User Guide (Full Version). When fax transmission is complete, the message "Transmission was finished." is displayed. When Fax Transmission Ended Sound is enabled, a sound is produced. See "Configuring the Type and Volume of the Sound Emitted When Using Fax", User Guide (Full Version). • If the telephone line you are connected to requires time to connect to the public line after you dial the external number, enter a [Pause] after entering the number to specify the time to wait before dialing the number. The machine pauses for about two seconds for each single [Pause] entered. • To use tone-dialing in a pulse-dialing environment, press [Tone]. A tone signal is generated for every number you enter afterward. • You can perform Immediate transmission only when the total number of destinations specified for all documents exceeds the maximum value. • The communication that has been initiated first is displayed on the screen when performing three simultaneous communications. 95