Sanyo CE42LH2WP IR Command List - Page 47
Specification Command with Address, 12. 5 CR_TEMP Command
UPC - 086483077777
View all Sanyo CE42LH2WP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
UK5 Specification of expanding serial command 9. 12. 5 CR_TEMP Command Command " "[CR] Detail Read current thermal status in the monitor If there are multiple thermal sensors, all thermal data can be acquired Receiving OK " "[CR] Temperature of sensor Temperature of sensor Temperature of sensor Outside Internal Internal is fixed 6 figures There is one space between and There is one space between and _ " _ indicate space. If temperature became below zero, this space indicated minus such as " " Status The last figure indicates status of thermal condition. " " Abnormal thermal status " " nearly abnormal thermal status Risky status " " Far form abnormal status safe status " " Not detecting abnormal thermal status " " Can not read thermal data If there are multiple sensors located, the sequential data can be read. example 1 "_31.5F□□35.2S□□38.0W"[CR] First data is from sensor 1, data from sensor 2 continues. (Example 1) indicates from sensor 1 is abnormal thermal status, from sensor 2 is safe status, from sensor 3 is nearly abnormal status. If hardware is fault, data shows E in last digit such as "_ " There may be abnormal thermal status occurs heat up after power is shout off. Such cases, the thermal data shows "_ " For UK5 chassis, below decimal does not appear. Since there is only one sensor for UK5, the read command is such as "__31F" [CR] Receiving NG "Error code"[CR] 10. Specification Command with Address Ver. Rev.A Page 47