Schwinn IC3 Indoor Cycling Bike Service Manual - Page 20

The Left Pedal is reverse-threaded., Final Inspection

Get Schwinn IC3 Indoor Cycling Bike PDF manuals and user guides View all Schwinn IC3 Indoor Cycling Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Disconnect the data cable from the console before you service this machine. Note: Your machine may not match the image. For reference only. 1. Loosen and remove the old Pedals. Discard the old Pedals. Note: The Left Pedal is reverse-threaded. Orientation is based from a seated position on the bike. The Left Pedal has an "L", the Right Pedal an "R". 2. Install the new Pedals. Carefully align the threads and hand tighten to prevent crossthreading. Then tighten fully with pedal wrench. Note: The Left Pedal is reverse-threaded. Be sure to attach Pedals on the correct side of the Bike. Orientation is based from a seated position on the bike. The Left Pedal has an "L", the Right Pedal an "R". 3. Final Inspection Inspect your machine to ensure that all hardware is tight and components are properly assembled. Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's Manual. 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
20
Note:
Your machine may not match the image. For reference only.
1.
Loosen and remove the old Pedals.
Discard the old Pedals.
Note:
The Left Pedal is reverse-threaded.
Orientation is based from
a seated position on the bike. The Left Pedal has an “L”, the
Right Pedal an “R”.
2.
Install the new Pedals. Carefully align the threads and hand tighten to
prevent crossthreading. Then tighten fully with pedal wrench.
Note:
The Left Pedal is reverse-threaded.
Be sure to attach Pedals
on the correct side of the Bike. Orientation is based from a
seated position on the bike. The Left Pedal has an “L”, the Right
Pedal an “R”.
3.
Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the Owner’s
Manual.
Disconnect the data cable from the console before you service this machine.