Schwinn IC3 Indoor Cycling Bike Service Manual - Page 6

Troubleshooting Condition/Problem 7KLQJVWR&KHFN Console will not power up/ Check batteries. turn on/start Check data cable integrity Check data cable connections/orientation Check console display for damage Speed displayed is not accurate Check Speed Sensor Magnet position Speed displayed is always Data cable "0"/stuck in Pause mode Speed Sensor No Speed/RPM reading Check data cable integrity Check data cable connections/orientation Check Speed Sensor Magnet position Check Speed Sensor Assembly Console display is dim Unit operates but Telemetric Heart Rate not displayed Batteries Chest Strap (optional) Chest Strap Batteries Interference Replace Chest Strap &RQVROHVKXWVRႇHQWHUV sleep mode) while in use Replace Console Check data cable integrity Check data cable connections/orientation Check batteries. Check Speed Sensor Magnet position Check Speed Sensor Assembly Solution Make sure batteries are installed correctly. If batteries are correctly installed, replace with a set of new batteries. All wires in cable should be intact. If any are visibly crimped or cut, replace cable. Make sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Check for visual sign that console display is cracked or otherwise damaged. Replace Console if damaged. If the above steps do not resolve the problem, contact Customer Care for further assistance. Speed Sensor Magnet should be in place on Flywheel. Make sure the data cable is connected to the Console and the main frame assembly. Make sure the RPM Sensor Magnet and the RPM Sensor are in place. All wires in cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Speed Sensor Magnet should be in place on Flywheel. Speed Sensor Assembly should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Replace batteries Strap should be "POLAR®" compatible and uncoded. Make sure strap is directly against skin and contact area is wet. If strap has replaceable batteries, install new batteries. Try moving unit away from sources of interference (TV, Microwave, etc). If interference is eliminated and HR does not function, replace strap. If HR still does not function, replace Console. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Make sure batteries are installed correctly. If batteries are correctly installed, replace with a set of new batteries. Speed Sensor Magnet should be in place on Flywheel. Speed Sensor Assembly should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Contact Customer Care for further assistance. 6