Schwinn IC3 Indoor Cycling Bike Service Manual - Page 58

18. Put the Drive Belt (P) in position on the Flywheel pulley (L1). Align WKH)O\ZKHHOD[OH- LQWKHÀ\ZKHHOEUDFNHWV+ +DQGWLJKWHQWKH hardware from steps 11 and 12 on each end of the Flywheel axle. NOTICE: Do not crimp any cables. 19. Put the Drive Belt (P) around the edge of the Drive Pulley (Q). Slowly turn the Drive Pulley and carefully walk the Drive Belt onto the Drive Pulley. Make sure the Drive Belt is aligned on the Flywheel pulley (L1) and Drive Pulley. %HVXUHWRNHHS¿QJHUVFOHDURIDOOSLQFK KD]DUGVDV\RXWXUQWKH'ULYH3XOOH\4 DQG Flywheel (L). 18. Tie the end of the string at the lower opening (R2) in the Frame upright to the end of the new Speed Sensor cable. Hold the other end of the string at the top opening (R1) and carefully pull the Speed Sensor cable up through the upright. NOTICE: Do not crimp the cable. 19. Reinstall the rubber grommets in the top opening (R1) and the lower opening (R2) in the left Frame upright to hold the Speed Sensor cable in position. Untie the string from the Speed Sensor cable (N1). NOTICE: Do not crimp the cable. P 4 / M J L R1 N1 R2 N2 20. Reassembly is the reverse procedure. NOTICE: Do not crimp any cables. Install the Flywheel Tensioners (G) at the position that you recorded in step 12. Make sure the Flywheel (L) can turn easily. Verify that the Speed Sensor (N) and Speed Sensor Magnet (R) on the Flywheel do not touch. Installation does not require the use of the crank puller. Be sure the Crank Arms are connected at 180° from each other. N R 21. Make sure that the Drive Belt tension is correct. Refer to the "Adjust the Belt Tension" procedure. 22. Final Inspection Inspect your machine to ensure that all hardware is tight and components are properly assembled. Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's Manual. 58