Sharp AR M207 AR-M162 AR-M207 Operation Manual Suite - Page 19
Turning The Power On And Off - scan
View all Sharp AR M207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
TURNING THE POWER ON AND OFF The power switch is located on the left side of the machine. POWER ON POWER OFF Turn the power switch to the "ON" position • It will take about 45 seconds for the machine to warm up. • When the power switch is turned to the "ON" position, the message "System check." will appear in the message display and warm-up will start. Once the copier has finished warming up, the message display will change to "Ready to copy." and the START indicator will light up to indicate that copying is possible. Copy settings can be selected during warm-up. • If auditing mode has been enabled (see the "Key operator's guide"), the message "Enter your account number." will appear after warming up. Once a valid account number has been entered, the message display will change to "Ready to copy." and copying will be possible. Make sure that the machine is not in operation and then turn the power switch to the "OFF" position. If the power switch is turned off while the machine is in 1 operation, a misfeed may occur and the job that was in progress will be canceled. Note • If the fax option is installed, be sure to keep the power turned on. Faxes cannot be received when the power is turned off. • The machine is set at the factory to return all settings to the default settings one minute after a copy job is finished (auto clear function). When the settings return to the default settings, any functions that were selected are canceled. The auto clear time can be changed in the key operator programs. (See the "Key operator's guide".) Power save modes The machine has two power save modes to reduce power consumption, thereby helping to reduce environmental pollution and conserve resources. Preheat mode This function automatically switches the machine to a low power consumption state if the duration of time set in the key operator programs elapses without the machine being used when the power is on. In preheat mode the display turns off. Normal operation automatically resumes when a key on the operation panel is pressed, an original is placed, or a print job or fax is received. Auto power shut-off mode This function automatically switches the machine to a state that consumes even less power than preheat mode if the duration of time set in the key operator programs elapses without the machine being used when the power is on. During auto power shut-off, only the mode key indicators are lit. To restore the machine to normal operation, press any one of the mode keys. Normal operation also resumes automatically when a print job or fax is received or scanning is begun from a computer. While auto power shut-off is in effect, pressing a key other than a mode key will have no effect. The preheat mode activation time and the "Auto power shut-off timer" can be changed in the key operator Note programs. (See the "Key operator's guide".) 17