Sharp XG-MB70X Setup Guide - Page 12
Controlling the Projector via LAN
View all Sharp XG-MB70X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Controlling the Projector via LAN After connecting the projector to your network, enter the projector IP address in "Address" on Internet Explorer (Version 5.0 or later) using a computer on the network to start a setup screen that will enable control of the projector via the network. Controlling the Projector Using Internet Explorer (Version 5.0 or later) Complete connections to external equipment before starting the operation. (See pages 2128 of the projector's operation manual.) Complete the AC cord connection. (See page 29 of the projector's operation manual.) Note • When connecting the projector to the LAN, use a LAN cable (Category 5). When connecting the projector to a hub, use a straight-through cable. 1 Start Internet Explorer (version 5.0 or later) on the computer. 2 Enter "http://" followed by the projector IP address set by the procedure on page 11 followed by "/" in "Address", and then press the "Enter" key. The factory default setting for the projector IP address is 192.168.150.2. If you did not change the IP address in "3. Setting up a Network Connection for the Projector" (page 10-11), enter "http://192.168.150.2/". 3 A screen for controlling the pro- jector appears, ready for performing various status conditions, control, and settings. -12