Sharp XG-MB70X Setup Guide - Page 17
Setting the Projector Using RS-232C or Telnet
View all Sharp XG-MB70X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Setting the Projector Using RS-232C or Telnet Connect the projector to a computer using RS-232C or Telnet, and open the SETUP MENU on the computer to carry out various settings for the projector. When Connecting Using RS-232C 1 Launch general purpose terminal emulator. 2 Input settings for the RS-232C port of the terminal emulator as follows. Baud Rate Data Length Parity Bit Stop Bit Flow Control : 9600 bps* : 8 bit : None : 1 bit : None ∗ This is the factory default setting. If the value of Baud Rate for the projector has been changed, set Baud Rate here according to the changed value on the projector. 3 Input "PJS11234" and press the "Enter" key. 4 "OK" is displayed. Input "PJS25678" and press the "Enter" key within 10 seconds. 5 "User Name:" is displayed. Input the user name and press the "Enter" key. • If a user name has not yet been set, just press the "Enter" key. 6 "Password:" is displayed. Input the password and press the "Enter" key. • If a password has not yet been set, just press the "Enter" key. 7 Input "setup" and press the "Enter" key. • SETUP MENU will be displayed. ▼SETUP MENU SETUP MENU [1]IP Address [2]Subnet Mask [3]Default Gateway [4]User Name [5]Password [6]RS-232C Baud Rate [7]Projector Name [A]Advanced Setup [D]Disconnect All [V]View All Setting [S]Save & Quit [Q]Quit Unchanged setup> Note • User name and password are not set in the factory default settings. • If the user name or password is entered incorrectly three times, SETUP MENU will be quit. -17