Sharp XG-MB70X Setup Guide - Page 26
Setting of Search Port, Return to Default Settings, Return to Main Menu
View all Sharp XG-MB70X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Controlling the Projector Using RS-232C or Telnet Setting of Search Port (ADVANCED[0]Search Port) Sets the port number used when searching for the projector from the network. advanced>0 1 Please Enter Port Number for Search from Computer. Valid range : 1025 to 65535 Search Port : 5006 Please Enter : 5004 2 (change) -> 5004 * 1 Enter "0" and press the "Enter" key. 2 Enter numerical value and press the"Enter"key. Display set numerical value (*). Return to Main Menu (ADVANCED[Q]Return to Main Menu) Returns to the main SETUP MENU. advanced>q 1 SETUP MENU [1]IP Address [2]Subnet Mask [3]Default Gateway [4]User Name [5]Password [6]RS-232C Baud Rate [7]Projector Name [A]Advanced Setup [D]Disconnect All [V]View All Setting [S]Save & Quit [Q]Quit Unchanged setup> 1 Enter "q" and press the "Enter" key. Returns to the SETUP MENU. Note • Set according to need. Normally, use with the factory default setting. Return to Default Settings (ADVANCED[!]Restore Default Setting) Returns all menu setting values to the default state. advanced>! 1 Restore All Setting to Default(y/n)? y 2 - User Setting Initialized - 1 Enter "!" and press the "Enter" key. 2 Enter "y" and press the "Enter" key. Note • If the values for IP Address, Subnet Mask or Gateway of the projector have been returned to the default settings via Telnet, the computer for controlling cannot be connected to the projector depending on the computer's network settings. -26