Sharp XG-MB70X Setup Guide - Page 25

Controlling the Projector Using RS-232C or Telnet Carrying out Network Ping Test (ADVANCED[5]Network Ping Test) It is possible to confirm that a network connection between the projector and a computer etc. is working normally. advanced>5 1 Ping dest IP addr :192.168.150.1 Please Enter :192.168.150.152 2 (change) -> 192.168.150.152 *1 32 bytes from 192.168.150.152: icmp_seq = 1, time = 0 ms 32 bytes from 192.168.150.152: icmp_seq = 2, time = 0 ms 32 bytes from 192.168.150.152: icmp_seq = 3, time = 0 ms *2 32 bytes from 192.168.150.152: icmp_seq = 4, time = 0 ms 1 Enter "5" and press the "Enter" key. 2 Enter IP address of device to be tested and press the "Enter" key. Display entered IP address (*1). Display test result (*2). Note • If the "Enter" key is pressed without entering an IP address, the Ping destination IP address used previously is entered. • If there is a fault with the connection, "Error: No answer" is displayed after a 5 second retry. In this case, please confirm the settings for the projector and the computer, and contact your network administrator. Setting of Accept IP Address (ADVANCED[6]Accept IP Addr(1) - [8]Accept IP Addr(3)) It is possible to improve security of the projector by allowing connection from only a prescribed IP address. It is possible to set up to three IP addresses allowing connection to the projector. advanced>6 1 Accept IP Addr(1) : 0.0.0.0 Please Enter : 192.168.150.152 2 (change) -> 192.168.150.152 * 1 Enter "6", "7" or "8" and press the "Enter" key. 2 Enter numerical value and press the"Enter"key. Display set numerical value (*). Note • To invalidate the Accept IP Address being currently set, enter "0.0.0.0". • If there is one or more Accept IP Addr being set, no connections are allowed from IP addresses that are not yet set. They can be cancelled using [9]Accept All IP Addr. Accepting All IP Addresses (ADVANCED[9]Accept All IP Addr) Removes IP addresses set with "Accept IP Addr". advanced>9 1 Accept All IP Addresses(y/n)? y 2 1 Enter "9" and press the "Enter" key. 2 Enter "y" and press the "Enter" key. Note • At the point in time where "y" was entered, the numerical values for Accept IP Addr(1)-(3) are reset to "0.0.0.0". • If "n" is entered, setting is not altered. -25