Sharp XG-MB70X Setup Guide - Page 14

Controlling the Projector via LAN Setting and Adjusting the Projector (Setting & Adjustment) Example: "Picture" screen display for INPUT 1 Setting the Security (Network - Security) On these screens, you can make projector settings or adjustments.You can set or adjust the following items : • Picture Mode • Bright Boost • CLR Temp • sRGB [OFF][ON] • IRIS • Signal Type • Auto Sync [OFF][ON] • Resize (INPUT 1) • OSD Display [OFF][ON] • Video System (INPUT 3/4) • Background • Eco Mode [OFF][ON] • Auto Power Off [OFF][ON] • Auto Focus (Startup) [OFF][ON] • Auto Keystone [OFF][ON] • Internal Speaker [OFF][ON] • Audio Out [OFF][ON] • Projection Mode • RS-232C Speed • Monitor Out (Standby) • OSD Language Note • If you click the "Refresh" button before the screen is displayed completely, an error message ("Server Busy Error") will be displayed. Wait for a moment and then operate again. • You cannot operate this page while the projector is warming up. • For details about each item, refer to the projector's operation manual. -14 On this screen, you can make settings relating to security. Items Description User Name Setting of user name for security protection. Password Setting of password for security protection. Accept IP It is possible to set up to three Addres IP addresses allowing connec- tion to the projector. All IP No limits are set to IP addresses Addresses connecting to the projector. From only For security improvement, only an specific IP IP address set by "Address 1-3" address can be connected to the projector. Note • User Name and Password can be up to 8 characters. • You can input the characters below : a-z, A-Z, 0-9, -, _