Sharp XG-MB70X Setup Guide - Page 24
Disconnecting All Connec, tions, Entering ADVANCED, SETUP MENU, Setting Auto Logout Time, Data Port
View all Sharp XG-MB70X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Controlling the Projector Using RS-232C or Telnet Disconnecting All Connections ([D]Disconnect All) It is possible to disconnect all the TCP/IP connections currently recognized by the projector. Even if the COM Redirect port is fixed in the Busy status due to a problem, it is possible to force the Ready status back by carrying out this disconnection. setup>d 1 Disconnect All Connections(y/n)?y 2 Now Disconnecting... 1 Enter "d" and press the "Enter" key. 2 Enter "y" and press the "Enter" key. Note • If Disconnect All is performed, the connection to the projector via network will be forcibly disconnected. Entering ADVANCED SETUP MENU ([A]Advanced Setup) Enters ADVANCED SETUP MENU. setup>a 1 ADVANCED SETUP MENU [1]Auto Logout Time [2]Data Port [5]Network Ping Test [6]Accept IP Addr(1) [7]Accept IP Addr(2) [8]Accept IP Addr(3) [9]Accept All IP Addr [0]Search Port [!]Restore Default Setting [Q]Return to Main Menu advanced> 1 Enter "a" and press the "Enter" key. Setting Auto Logout Time (ADVANCED[1]Auto Logout Time) If there is no input after a fixed time, the projector automatically disconnects network connection using the Auto Logout function. It is possible to set the time until the projector is automatically disconnected in units of a minute (from 1 to 65535 minutes). advanced>1 1 Valid range : 0 to 65535 (minute) note: if you enter "0", auto logout function will be disable. Auto Logout Time : 5 Please Enter :15 2 (change) -> 15 * 1 Enter "1" and press the "Enter" key. 2 Enter numerical value and press the"Enter"key. Display set numerical value (*). Note • If the set value is made 0, the Auto Logout function is disabled. • If an invalid number is entered, an error message ("Parameter Error!") will be displayed and returns the ADVANCED SETUP MENU. Data Port Setting (ADVANCED[2]Data Port) Setting of TCP port number can be set in the range of 1025 to 65535. advanced>2 1 Valid range :1025 to 65535 Data Port :10002 Please Enter :10005 2 (change) -> 10005 * 1 Enter "2" and press the "Enter" key. 2 Enter numerical value and press the"Enter"key. Display set numerical value (*). Note • Set according to need. Normally, use with the factory default setting. -24