Sony SLV-M11HF Operating Instructions - Page 22

Playing/searching at various speeds continued, To use the shuttle ring in jog mode - tracking

Page 22 highlights

Playing/searching at various speeds (continued) To use the shuttle ring in jog mode Use this mode for frame-by-frame playback. Press JOG to enter the jog mode. The JOG button lights up. If you change to the jog mode during any playback mode, the playback pauses so you can see a still picture. Each change in the shuttle ring position shifts the picture one frame. To shift frames in reverse, turn the shuttle ring counterclockwise. The frame shift speed depends on the speed you turn the shuttle ring. To resume normal mode, press JOG again. The JOG button goes off. Tip • Adjust the picture using the TRACKING +/- buttons if: - Streaks appear while playing in slow motion. - The picture shakes while pausing. To set tracking to the center position, press both buttons (+/-) at the same time. Notes • The sound is muted during these operations. • Tapes recorded in the LP mode on other VCRs can be played back on this VCR but the picture quality cannot be guaranteed. • The picture may have snow: - when playing at high speed in reverse - when playing in reverse slow motion - when playing in reverse • If the playback mode mark doesn't appear on the TV screen, press DISPLAY. • The picture may flutter a bit when playing in slow motion. 22 Additional Operations

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76

Additional Operations
22
To use the shuttle ring in jog mode
Use this mode for frame-by-frame playback.
Press JOG to enter the jog mode.
The JOG button lights up.
If you change to
the jog mode during any playback mode, the playback pauses so you can see
a still picture.
Each change in the shuttle ring position shifts the picture one
frame.
To shift frames in reverse, turn the shuttle ring counterclockwise.
The frame shift speed depends on the speed you turn the shuttle ring.
To resume normal mode, press JOG again.
The JOG button goes off.
Tip
Adjust the picture using the TRACKING +/– buttons if:
– Streaks appear while playing in slow motion.
– The picture shakes while pausing.
To set tracking to the center position, press both buttons (+/–) at the same time.
Notes
The sound is muted during these operations.
Tapes recorded in the LP mode on other VCRs can be played back on this VCR but
the picture quality cannot be guaranteed.
The picture may have snow:
– when playing at high speed in reverse
– when playing in reverse slow motion
– when playing in reverse
If the playback mode mark doesn’t appear on the TV screen, press DISPLAY.
The picture may flutter a bit when playing in slow motion.
Playing/searching at various speeds (continued)