Sony VPL-PX10 Operating Instructions - Page 35
Notes for Installation, Unsuitable Installation, Unsuitable Conditions for Use
View all Sony VPL-PX10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Installation Notes for Installation Notes for Installation Very dusty Unsuitable Installation Do not install the projector in the following situations. These installations may cause malfunction or damage to the projector. Poorly ventilated Avoid installing the unit in a location where there is a lot of dust; otherwise, the air filter will clog. The dust blocking the air through the filter may cause the internal heat level of the projector to rise. Clean the filter periodically. Unsuitable Conditions for Use Do not do any of the following. PUSH • Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies) that may block the ventilation holes. When internal heat builds up due to blockage of the ventilation holes, the temperature sensor may function, a warning message will be displayed, and the power may be turned off automatically after one minute. • Leave space of more than 50 cm (19 3/4 inches) around the unit. • Be careful that the ventilation holes do not inhale tiny objects such as pieces of paper. Toppling the unit Avoid standing the unit on its side as the unit may topple over. This may cause a malfunction. Tilting the unit more than 15 degrees Highly heated and humid PUSH • Avoid installing the unit in a location where the temperature or humidity is very high, or the temperature is very low. • To avoid moisture condensation, do not install the unit in a location where the temperature may rise rapidly. Avoid tilting the unit at an angle of more than 15 degrees. Installation of the unit in this manner may cause a malfunction. 35 (GB)