Sony VPL PX31 Operating Instructions - Page 15
Setting up and pr, ojecting - sxga
UPC - 027242578814
View all Sony VPL PX31 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Connecting Setting up and projecting Connecting Connecting with a Computer This section describes how to connect the projector to a computer. You can control the projector from your computer by using the application software supplied with the projector, and/or you can use USB equipment. For details, see "Using USB equipment (e.g., USB mouse)". When the projector is connected to a computer, you can control the mouse of a computer by the Remote Commander. The R/L CLICK keys and joy stick function as follows. • insert the plugs of the cables properly; plugs that are not fully inserted often generate noise. When pulling out a cable, be sure to pull it out from the plug, not the cable itself. Notes • Connect all the connecting cables to the INPUT A connector when you input a signal from the INPUT A connector. Connect all the cables to the INPUT B connector when you input a signal from the INPUT B connector as well. • Supplied mouse cables may not work properly according to your computer. Note Make sure that there is nothing to obstruct the infrared beam between the Remote Commander and the remoter control detector on the projector. When connecting with an IBM PC/AT compatible computer Key and joy stick R CLICK (front) L CLICK (rear) Joy stick Function IBM PC/AT1) compatible, Serial Right button Macintosh Mouse button Left button Mouse button Corresponds with the movements of the mouse Right side DIGITAL RGB RGB 5BNC REMOTE RS-232C OUTPUT CONTROL S VIDEO IN IN PLUG IN POWER S VIDEO VIDEO INPUT B L R (MONO) AUDIO MONITOR INPUT A USB AUDIO DIGITAL RGB RGB 5BNC RGB RGB AUDIO MOUSE AUDIO MOUSE DIGITAL RGB R/R-Y/PR G/Y B/B-Y/PB SYNC/HD VD to INPUT A or INPUT B Also refer to the instruction manual of equipment to SIC-S21 (for be connected. Notes • This unit accepts the VGA, SVGA, XGA or SXGA Speaker HD D-sub 15-pin cable (supplied) serial)/S22 (for PS/2) Mouse cable (supplied) Stereo audio signals. However, we recommend you to set the output signal of your computer to the XGA. • If you set your computer, such as a notebook type IBM PC/AT compatible, to output the signal to both the display of your computer and the external Monitor cable SMF-410 (not supplied) connecting cable (not supplied) monitor, the picture of the external monitor may not appear properly. In such cases, set the output mode of your computer to output the signal to only the external monitor. Monitor to monitor out to audio out to serial port or to mouse For details, refer to the operating instructions supplied port with your computer. • The RGB input connectors of the INPUT A/B and DIGITAL RGB connector of the INPUT A comply with the VESA DDC2B. If your computer or graphics board is compatible with DDC, turn on the power of the equipment as follows: Computer 1 Connect the projector to the computer with the HD D-sub 15-pin cable. 2 Turn on the power of the projector. 3 Boot up the computer. Note Set the DIGITAL RGB/5BNC/RGB switch to RGB When making connections, be sure to: • turn off all equipment before making any connections. (right) when you connect the computer to the INPUT A connector. • use the proper cables for each connection. ... 1) IBM and PC/AT are a trademark and a registered trademark of International Business Machines Corporation, U.S.A. 15 (GB)