Sony VPL PX31 Operating Instructions - Page 17

Using USB equipment (e.g., USB mouse) Connect the USB equipment to the USB connector on the connector panel. You can connect your computer to the projector via the RGB connector, 5BNC connector or DIGITAL RGB connector. (The example below uses the RGB connector.) Right side DIGITAL RGB RGB 5BNC REMOTE RS-232C OUTPUT CONTROL S VIDEO IN IN PLUG IN POWER S VIDEO VIDEO INPUT B L R (MONO) AUDIO MONITOR INPUT A USB AUDIO DIGITAL RGB RGB 5BNC RGB RGB AUDIO MOUSE AUDIO MOUSE DIGITAL RGB R/R-Y/PR G/Y B/B-Y/PB SYNC/HD VD USB cable A type-B type (supplied) Other USB equipment Stereo audio connecting cable (not supplied) HD D-sub 15-pin cable (supplied) to USB port to monitor out to audio out Computer Note Set the DIGITAL RGB/5BNC/RGB switch to the suitable position depending on the connection. On the USB function When connecting the projector to a computer by using the USB cable for the first time, the computer recognizes the following devices automatically. 1 USB hub (general use) 2 USB human interface device (wireless mouse function) 3 USB human interface device (projector control function) The computer also recognizes the device connected to the downstream connector on the projector. Recommended operating environment When you use the USB function, connect your computer as illustrated above. This application software and the USB function can be used on a computer loaded with Windows 98, Windows 98 SE or Windows 2000 preinstall models. Connecting Notes • As the projector recognizes the USB mouse when the computer is connected to the USB connector, do not connect anything to the MOUSE connector. • Your computer may not start correctly when connected to the projector via the USB cable. In this case, disconnect the USB cable, restart the computer, then connect the computer to the projector using the USB cable. • This projector is not guaranteed for suspend, standby mode. When you use the projector in suspend, standby mode, disconnect the projector from the USB port on the computer. • Operations are not guaranteed for all the recommended computer environments. Connecting with a VCR/15k RGB/ Component Equipment This section describes how to connect the projector with a VCR, external active speakers, and 15k RGB/ component equipment. Also refer to the instruction manuals of the equipment to be connected. When making connections, be sure to: • turn off all equipment before making any connections. • use the proper cables for each connection. • insert the plugs of the cables properly; plugs that are not fully inserted often generate noise. When pulling out a cable, be sure to pull it out from the plug, not the cable itself. Right side REMOTE RS-232C OUTPUT CONTROL S VIDEO IN IN PLUG IN POWER S VIDEO VIDEO INPUT B L R (MONO) AUDIO MONITOR INPUT A USB AUDIO DIGITAL RGB RGB 5BNC RGB RGB AUDIO MOUSE AUDIO MOUSE DIGITAL RGB R/R-Y/PR G/Y B/B-Y/PB SYNC/HD VD S-Video cable (not supplied) to S video output Audio/video cable (supplied) to audio/video outputs Active speakers VCR 17 (GB)