Stihl MS 150 C-E Instruction Manual - Page 38
uncoil during this operation
View all Stihl MS 150 C-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
2011BA040 KN English Removing the Rope Rotor Replacing a Broken Starter Rope 1 2 3 N Loosen screw (1) on carrier (2). N Carefully pull the carrier (2) off the rope rotor (3). 2011BA033 KN N Pry the cap out of the starter grip. N Remove the remaining rope from the rotor and starter grip. 000BA072 KN N Pull out the starter rope about 15 cm and hold the rope rotor steady. N Take three turns off the rope rotor. N Pull the rope out with the starter grip and keep it under tension - then let go of the rope rotor. N Slowly release the starter rope until it goes slack. The rewind spring is no longer under tension when the starter rope is not wound completely onto the rope rotor and can be unwound by hand. 3 N Carefully remove the rope rotor (3). WARNING The rewind spring may pop out and uncoil during this operation - take care to avoid the risk of injury. 2011BA034 KN N Thread the new rope through the starter grip and tie a simple overhand knot. N Pull the knot back into the grip. N Refit the cap in the grip. 2011BA041 KN 36 MS 150 TC