Symphonic TVCR13F1W Owner's Manual - Page 26
Troubles, Ooting
View all Symphonic TVCR13F1W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
TROUBLES OOTING GUI 'E If you have followed the instructions contained in this manual and have difficulty in operating your TV/VCR, locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to remedy the problem. SYMPTOM No power. POSSIBLE CAUSE • AC Power cord is not connected. CORRECTIVE ACTION • Connect AC power cord to AC outlet. • POWER button is set to OFF. • Set the POWER button to ON. No picture and sound. • TV/VCR is not plugged into an • Plug power cord into an active AC outlet. active AC outlet. • Antenna is not connected. • Check antenna connection. • No channel in memory. • Program tuner's memory. No picture or poor pic- • Direction or condition of antenna is • Adjust direction or replace antenna. ture on TV/VCR. not adequate. • Picture control is not adequate. • Adjust picture controls. No sound or poor sound. • Volume control on remote control • Adjust volume control on remote control unit or main unit is in minimum unit or set. position. • MU IE button on the remote control • Press MUTE button. unit is in the ON position. Timer recording is not • The timer recording is set incorrectly. • Set the timer recording correctly. possible. • The timer recording is not set to ON. • Set the timer recording to ON. Cannot go into Record • The erase-prevention tab on cassette • Place transparent tape over missing mode. is missing. erase-prevention tab. Playback picture is par- • The TRACKING control is not set • Adjust TRACKING control for better tially noisy. correctly. picture. Noise in picture on play- • Video heads are dirty. back. • Head cleaning is necessary, consult the nearest Funai Service Center. No operation by infrared • No power to TV/VCR. Remote Control. • Make sure the AC cord is connected to an AC outlet. • Weak batteries. • Check the batteries in infrared Remote Control. - 26 - EN 6A30