TP-Link RE305 RE305EU V1 User Guide - Page 36

LED remains lit., On your router

Get TP-Link RE305 PDF manuals and user guides View all TP-Link RE305 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

filter, wireless access control, or ACL is enabled, the devices connected to the extender cannot get an IP address from the extender and cannot access the Internet. To solve this problem, please follow the steps below: 1. Log in to your router and disable the MAC filter, wireless access control or ACL. Note: For more information about how to disable your router's MAC filter, wireless access control or ACL, please refer to your router's user guide. 2. Power on your extender, and run the Quick Setup to configure your extender. 3. Connect all of your devices to the extended network, and make sure the router's Link LED remains lit. 4. On your router, add all the Online Devices' MAC addresses to your router's MAC filter table. 5. Enable the router's MAC filter, wireless access control, or ACL. Now, you have successfully configured your extender. 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
33
filter, wireless access control, or ACL is enabled, the devices
connected to the extender
cannot get an IP address from the extender and cannot access the Internet.
To solve this problem, please follow the steps below:
1. Log in to your router and disable the MAC filter, wireless access control or ACL.
Note:
For more information about how to disable your router’s MAC filter, wireless access control or ACL, please
refer to your router’s user guide.
2. Power on your extender, and run the
Quick Setup
to configure your extender.
3. Connect all of your devices to the extended network, and make sure the router’s Link
LED remains lit.
4. On your router, add all the Online Devices’ MAC addresses to your router’s MAC filter
table.
5. Enable the router’s MAC filter, wireless access control, or ACL.
Now, you have successfully configured your extender.