TP-Link T2600G-28MPS T2600G-28MPSUN V1 User Guide - Page 148
Network Diagram, Configuration Procedure, Ethernet OAM→, DLDP→ DLDP, DLDP→, Reset
View all TP-Link T2600G-28MPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Network Diagram Figure 8-13 DLDP Application Example Configuration Procedure Step Operation Description 1 Enable DLDP globally. Required. On the Ethernet OAM→ DLDP→ DLDP page, configure DLDP State as enable under the Global Config tab in device A and B. 2 Enable DLDP on the Required. On the Ethernet OAM→ DLDP→ DLDP page, specified ports. configure DLDP State as enable on Gigabit Ethernet ports 1/0/27 and 1/0/28 in the Port Config table in device A and device B. 3 Configure Shut Mode. Required. On the Ethernet OAM→ DLDP→ DLDP page, configure the Shut Mode as auto under the Global Config tab in device A and B. 4 Check the ports' state. Required. On the Ethernet OAM→ DLDP→ DLDP page, select ports 1/0/27 and 1/0/28 in the Port Config table and click the Reset button to bring them up. The DLDP information of Gigabit Ethernet ports 1/0/27 and 1/0/28 is shown below: 137