TP-Link T2600G-28MPS T2600G-28MPSUN V1 User Guide - Page 257
ACL Config, IPv6 ACL, Create Extend-IP ACL, Permit
View all TP-Link T2600G-28MPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
Choose the menu ACL→ACL Config→IPv6 ACL to load the following page. Figure 13-10 IPv6 ACL Config The following entries are displayed on this screen: Create Extend-IP ACL ACL ID: Rule ID: Select the desired IPv6 ACL for configuration. Enter the rule ID. Operation: DSCP: Flow Label: Select the operation for the switch to process packets which match the rules. Permit: Forward packets. Deny: Discard Packets. Enter the DSCP information contained in the rule. Enter the Flow Label information contained in the rule. IPv6 Source IP: Click to enable the IPv6 source IP verification. S-IP: Enter the source IPv6 address contained in the rule, you can input all the 128 bits, but only upper 64 bits are verified. Mask: Enter IP address mask. If it is set to 1, the upper 64 bits in the source address of the packet must strictly match the S-IP you configured. This field is 64-bit long. IPv6 Destination IP: Click to enable the IPv6 destination IP verification. 246