TP-Link TL-SG3109 User Guide - Page 34

Initial Configuration, The device is not configured with a default user name and password.

Get TP-Link TL-SG3109 - Switch PDF manuals and user guides
UPC - 845973020484
View all TP-Link TL-SG3109 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

TL-SG3109/TL-SL3428/TL-SL3452 Gigabit Managed Switch Family Installation Guide Note After making any configuration changes, the new configuration must be saved before rebooting. To save the configuration, enter: console# copy running-config startup-config 4.4.1 Initial Configuration Initial configuration, which starts after the device has booted successfully, includes static IP address and subnet mask configuration, and setting user name and privilege level to allow remote management. If the device is to be managed from an SNMP-based management station, SNMP community strings must also be configured. The following configurations are completed: The initial simple configuration uses the following assumptions:  The device was never configured before, and is in the same state as when it was received.  The device booted successfully.  The Serial connection is established and the console prompt is displayed on the screen of a VT100 terminal device. (Press the key several times to verify that the prompt displays correctly.)  The device is not configured with a default user name and password. The initial device configuration is through the Serial port. After the initial configuration, the device can then be managed either from the already connected Serial port or remotely through an interface defined during the initial configuration. The initial configuration consists of the following: 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
27
Gigabit Managed Switch Family Installation Guide
TL-SG3109/TL-SL3428/TL-SL3452
Note
After making any configuration changes, the new configuration must be saved
before rebooting. To save the configuration, enter:
console#
copy running-config startup-config
4.4.1
Initial Configuration
Initial configuration, which starts after the device has booted successfully,
includes static IP address and subnet mask configuration, and setting user
name and privilege level to allow remote management. If the device is to be
managed from an SNMP-based management station, SNMP community
strings must also be configured. The following configurations are completed:
The initial simple configuration uses the following assumptions:
The device was never configured before, and is in the same state as when
it was received.
The device booted successfully.
The Serial connection is established and the console prompt is displayed
on the screen of a VT100 terminal device. (Press the <Enter> key several
times to verify that the prompt displays correctly.)
The device is not configured with a default user name and password.
The initial device configuration is through the Serial port. After the initial
configuration, the device can then be managed either from the already
connected Serial port or remotely through an interface defined during the initial
configuration.
The initial configuration consists of the following: