TRENDnet THA-103AC User's Guide - Page 25

Europe - EU Declaration of Conformity

Page 25 highlights

TRENDnet User's Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channel is not possible. This device is restricted for indoor use. This device and it's antennas (s) must not be co‐located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi‐transmitter product procedures. The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user. Europe - EU Declaration of Conformity THA‐103AC Europe - EU Declaration of Conformity This device complies with the essential requirements of the Directive 2004/108/EC, /2006/95/EC and 2009/125/EC: EN 300328: 1.8.1 2012 EN 301489‐1: 1.9.2 2011‐9 EN 55022: 2010 / AC: 2011 Class B EN 55024: 2010 EN 62311: 2008 EN 50385: 2002 EN 60950‐1: 2006 + A11 + A1: 2010 + A12: 2011 + A2: 2013 Safety of Information Technology Equipment including electrical business equipment RoHS This product is RoHS compliant. © Copyright 2015 TRENDnet. All Rights Reserved. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29

© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
THA
103AC
23
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This
equipment
complies
with
FCC
radiation
exposure
limits
set
forth
for
an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channel is not possible. This device is restricted for indoor use. This
device and it’s antennas (s) must not be co
located or operating in conjunction with any
other antenna or transmitter except in accordance with FCC multi
transmitter product
procedures.
The availability of some specific channels and/or operational frequency bands are
country dependent and are firmware programmed at the factory to match the intended
destination. The firmware setting is not accessible by the end user.
Europe – EU Declaration of Conformity
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the Directive
2004/108/EC, /2006/95/EC and 2009/125/EC:
EN 300328: 1.8.1 2012
EN 301489
1: 1.9.2 2011
9
EN 55022: 2010 / AC: 2011 Class B
EN 55024: 2010
EN 62311: 2008
EN 50385: 2002
EN 60950
1: 2006 + A11 + A1: 2010 + A12: 2011 + A2: 2013 Safety of
Information Technology Equipment including electrical business equipment
RoHS
This product is RoHS compliant.