TRENDnet TV-IP420P Users Guide - Page 57

Restore Default Password

Get TRENDnet TV-IP420P PDF manuals and user guides View all TRENDnet TV-IP420P manuals
Add to My Manuals
Save this manual to your list of manuals

Page 57 highlights

TRENDnet User's Guide TV‐IP420P Clear Config You can clear PTZ configurations all at once in this section, select the desire function and click Save to clear. Restore Default Password Software Reset Refer to Advanced Settings, Maintenance section. Hardware Reset Follow the steps to perform a hardware reset 1. Disconnect the power source (Network Cable from PoE injector or switch) e from the camera 2. Open the back cover behind the lens and find the reset button © Copyright 2016 TRENDnet. All Rights Reserved. 3. Press and hold the reset button then connects the power source (Network Cable from PoE injector or switch) back to the device. Release the reset button after 20 seconds. Wait for 1 minute for camera to reboot. The device has now been reset. 4. Login to the camera to see if the password has been reset. 5. Close the cover and configure the camera again. 57

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
TRENDnet User’s Guide
TV
‐
IP420P
© Copyright 2016 TRENDnet. All Rights Reserved.
57
Clear Config
You can clear PTZ configurations all at once in this section, select the desire function and click
Save
to clear.
Restore Default Password
Software Reset
Refer to
Advanced
Settings,
Maintenance
section.
Hardware Reset
Follow the steps to perform a hardware reset
1.
Disconnect the power source (Network Cable from PoE injector or switch) e from
the camera
2.
Open the back cover behind the lens and find the reset button
3.
Press and hold the reset button then connects the power source (Network Cable
from PoE injector or switch) back to the device. Release the reset button after 20
seconds. Wait for 1 minute for camera to reboot. The device has now been reset.
4.
Login to the camera to see if the password has been reset.
5.
Close the cover and configure the camera again.