Toshiba DVR610 Service Manual - Page 22
Troubleshooting
UPC - 022265001370
View all Toshiba DVR610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
TROUBLESHOOTING NOTE: BOARD MEANS PRINTED CIRCUIT BOARD. 1 Power Supply Section FLOW CHART NO.1 The power cannot be turned on. No Is the fuse normal? Yes Is normal state restored when once unplugged No power cord is plugged again after several seconds. Yes Is the AL+12V line voltage normal? No Yes Check each rectifying circuit of secondary circuit and replace P1 (BOARD MCV) if defective. FLOW CHART NO.2 The fuse blows out. See FLOW CHART No.2 Check for lead or short-circuiting of primary circuit component and replace P3 (BOARD POWER SUPPLY) if defective. (Q1001, Q1003, T1001, D1001, D1002, D1003, D1004, D1011, D1028, C1003, C1035, C1036) Check the presence that the primary component is leaking or shorted and replace P3 (BOARD POWER SUPPLY) if defective. Check the presence that the rectifying diode or circuit is shorted in each rectifying circuit of secondary side and replace P1 (BOARD MCV) if defective. After servicing, replace the fuse (F1001). FLOW CHART NO.3 When the output voltage fluctuates. Does the secondary side photo coupler circuit No Check the circuit and replace P3 (BOARD POWER operate normally? SUPPLY) if defective. Yes (IC1010, Q1031, D1017, D1025, D1036) Check the circuit and replace P3 (BOARD POWER SUPPLY) if defective. (IC1010, D1006, D1010, D1029) FLOW CHART NO.4 When buzz sound can be heard in the vicinity of power circuit. Check if there is short circuit on the rectifying diode and the circuit in each rectifying circuit of secondary side and replace P1 (BOARD MCV) or P3 (BOARD POWER SUPPLY) if defective. P1 (BOARD MCV) : IC2503, IC2504, Q1055, Q1056, Q1057, Q1101, Q1102, Q1104 P3 (BOARD POWER SUPPLY) : D1012, D1013, D1014, D1015, D1016, D1018, D1021, D1022, D1023, D1034 FLOW CHART NO.5 AL-30V is not outputted. No Is the supply voltage of -30V fed to the anode of D1018? Yes Check for load circuit short-circuiting or leak, and replace P1 (BOARD MCV) if defective. Check D1018 and their periphery, and replace P3 (BOARD POWER SUPPLY) if defective. 1-10-1 E9KGATR