URC URC-WR7 Owners Manual - Page 13

3. Auto-Search Set-up The Auto-Search Set-up scans through all of the codes in the table to find the right code for your component. Use this method for components you cannot set up with either the Quick Set- Up or 3-Digit Set-up. This step is not difficult, but tests your patience, as it takes about five minutes to work through the entire table. STEP 1: Turn on the component you want to activate. (Other components can be on or off, it doesn't matter.) STEP 2: On the WR7, press the Component button that you want to set up and the SELECT [SEL] button at the same time. Hold down both buttons for two seconds until the Component button light turns on. This signals that you are in set-up mode and can release the buttons. UP5 ARROW SELECT BUTTION STEP 3: Point the WR7 remote control toward the component and press the UP or the DOWN arrow button on the navigation pad. Each time the UP or DOWN arrow button is pressed, the code will count up (or down) one code number and send a Power OFF signal to the component. UP5 ARROW Navigation Pad 6 DOWN ARROW Page | 12