URC URC-WR7 Owners Manual - Page 20

What to know before you start

Get URC URC-WR7 PDF manuals and user guides View all URC URC-WR7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

What to know before you start: • You can program up to 20 sequential commands on a Macro button. • You can program delays in between commands by pressing the [PAUSE] button on the transport control. - Each press adds a one-half second delay. - If you add the delay time as the first step of Macro commands, the remote will not send the Macro unless the button is held for two seconds. • You can set up macro commands in layers by pressing the [STOP] button in between commands. This will allow you to rotate commands, and is typically used to program channel lists. For example, when working the "My Favorites" button, if you press [009], [STOP], [035], [STOP], [365], [STOP] the remote will send out 009 at the first press of the selected [My Favorites] button, and then send out 035 at the second press, etc. 56 • You cannot set-up the [CH ] or [PAUSE;] buttons with macros. • You also can set up the "FAV" button above the channel control as a favorite macro (like watch a movie), or you can save it to learn your favorite channel list from your cable/SAT remote control. Page | 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Page | 19
What to know before you start:
• You can program up to 20 sequential
commands on a Macro button.
• You can program delays in between
commands by pressing the [PAUSE]
button on the transport control.
–
Each press adds a one-half second delay.
–
If you add the delay time as the first step
of Macro commands, the remote will not
send the Macro unless the button is held
for two seconds.
• You can set up macro commands in layers
by pressing the [STOP] button in between
commands. This will allow you to rotate
commands, and is typically used to program
channel lists. For example, when working the
“My Favorites” button, if you press [009],
[STOP], [035], [STOP], [365], [STOP] the
remote will send out 009 at the first press of
the selected [My Favorites] button, and then
send out 035 at the second press, etc.
• You cannot set-up the [CH
56
] or
[PAUSE
;
] buttons with macros.
• You also can set up the “FAV” button above
the channel control as a favorite macro (like
watch a movie), or you can save it to learn
your favorite channel list from your cable/SAT
remote control.