URC URC-WR7 Owners Manual - Page 28

Controls Play, Stop, Ff, Rew, Pause, Skip

Get URC URC-WR7 PDF manuals and user guides View all URC URC-WR7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Channel Control Punch Through This punch through enables you to set up the WR7 remote so that VCR or DVD Transport Controls (PLAY, STOP, FF, REW, PAUSE, SKIP and RECORD) will also operate in other component modes on the remote control. STEP 1: Press and hold the component button you want to add Transport Control to, such as [CABLE/SAT] or [TV], and the SELECT [SEL] button at the same time for two seconds until the Component LED light turns on. STEP 2: Press the [PLAY] button. The component LED light will blink once. Note: If you do not press a button within 30 seconds, the component light will turn off. The remote will exit the set up mode, and you will have to start over with step one. STEP 3: Press either the [DVD] or [VCR] button that you want to use as the source of Transport Control. The component light will blink three times to confirm it is saved. COMPONENT BUTTONS SELECT PLAY Transport controls Page | 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Page | 27
Channel Control Punch Through
This punch through enables you to set up the
WR7 remote so that VCR or DVD Transport
Controls (PLAY, STOP, FF, REW, PAUSE, SKIP
and RECORD) will also operate in other
component modes on the remote control.
STEP 1:
Press and hold the component
button you want to add Transport Control to,
such as [CABLE/SAT] or [TV], and the SELECT
[SEL] button at the same time for two seconds
until the Component LED light turns on.
STEP 2:
Press the [PLAY] button.
The component LED light will blink once.
Note:
If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set up mode, and you
will have to start over with step one.
STEP 3:
Press either the [DVD] or [VCR]
button that you want to use as the source of
Transport Control. The component light will
blink three times to confirm it is saved.
Transport controls
COMPONENT
BUTTONS
SELECT
PLAY