URC URC-WR7 Owners Manual - Page 27

Channel Control Punch Through

Get URC URC-WR7 PDF manuals and user guides View all URC URC-WR7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Channel Control Punch Through This punch through lets you set up the WR7 remote so that either the Cable or TV Channel Controls (CHANNEL UP, DOWN, LAST, CHANNEL NUMBERS 0-9, +10 and ENTER) will also operate in other component modes on the remote control. STEP 1: Press and hold the component button you want to add channel control to, such as [DVD] or [VCR], and the SELECT [SEL] button at the same time for two seconds until the Component light turns on. Release the buttons. COMPONENT BUTTONS SELECT BUTTONS 5 STEP 2: Press the CHANNEL UP [CH ] button. The component LED light will blink once. Note: If you do not press a button within 30 seconds, the component light will turn off. The remote will exit the set up mode, and you will have to start over with step one. STEP 3: Press either the [TV] or [CABLE/SAT] button that you want to use as the source of channel control. The component light will blink three times to confirm it is saved. Page | 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Page | 26
Channel Control Punch Through
This punch through lets you set up the WR7
remote so that either the Cable or TV Channel
Controls (CHANNEL UP, DOWN, LAST,
CHANNEL NUMBERS 0-9, +10 and ENTER)
will also operate in other component modes on
the remote control.
STEP 1:
Press and hold the component
button you want to add channel control to, such
as [DVD] or [VCR], and the SELECT [SEL] button
at the same time for two seconds until the
Component light turns on. Release the buttons.
STEP 2:
Press the CHANNEL UP [CH
5
]
button. The component LED light will blink once.
Note:
If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set up mode, and you
will have to start over with step one.
STEP 3:
Press either the [TV] or [CABLE/SAT]
button that you want to use as the source of
channel control. The component light will
blink three times to confirm it is saved.
COMPONENT
BUTTONS
SELECT
BUTTONS