URC URC-WR7 Owners Manual - Page 31

Component, Buttons, Enter, Button

Get URC URC-WR7 PDF manuals and user guides View all URC URC-WR7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Erasing a Single Learned Command from One Component STEP 1: Press the component button where the learned command is stored and the [ENTER] button at the same time for two seconds until the component LED light turns on. COMPONENT BUTTONS ENTER BUTTON STEP 2: Press and hold the button you want to erase for two seconds. The component light will blink twice to confirm the erasure. Note: If you do not press a button within 30 seconds, the component light will turn off. The remote will exit the set up mode, and you will have to start over with step one. STEP 3: Repeat Step 2 to erase any other buttons in the selected component mode. STEP 4: To exit Erase mode, press and hold both the component button and the [ENTER] button at the same time until the component light blinks three times. Page | 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
Page | 30
Erasing a Single Learned
Command from One Component
STEP 1:
Press the component button where the
learned command is stored and the [ENTER]
button at the same time for two seconds until
the component LED light turns on.
STEP 2:
Press and hold the button you want
to erase for two seconds. The component
light will blink twice to confirm the erasure.
Note:
If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the set up mode, and
you will have to start over with step one.
STEP 3:
Repeat Step 2 to erase any other
buttons in the selected component mode.
STEP 4:
To exit Erase mode, press and hold
both the component button and the [ENTER]
button at the same time until the component
light blinks three times.
COMPONENT
BUTTONS
ENTER
BUTTON