URC URC-WR7 Owners Manual - Page 21

MacroPower™ Total System On or Off MacroPower makes several devices work together while pressing just one button. If you want to turn on your TV, DVD player and Surround Sound receiver by pressing a single button, you can. Both the Power Onand the System Off buttons can be set up for MacroPower control. Note: Most components use the same signal to turn the power on and off. You may want to set-up MacroPower only in the POWER [ON] button and save the [SYSTEM OFF] button to turn components on or off individually. STEP 1: To set-up MacroPower for the POWER [ON] button, press the POWER [ON] button and the [MUTE] button at the same time for two seconds until any one of the Component lights turns on. Release the buttons before going on to step 2. POWER ON SYSTEM OFF MUTE 5 CHANNEL UP STEP 2: Press the component button you want to turn on and then press the POWER [ON] button; repeat for all other components in the order you want them to turn on. The Component light will blink once each time you press the POWER [ON] button. Note: If you do not press a button within 30 seconds, the component light will turn off. The remote will exit the set-up mode, and you will have to start over with step one. STEP 3: Once you've entered all the Power On 5 commands, press the CHANNEL Up [CH ] button to save your MacroPower commands. The Component light will blink three times to confirm that the activation has been successfully saved. Repeat for System Off button if desired. Page | 20